Installation instructions
1. Go to the folder where the crosshairs are located (the label is "crosshairs").
2. Select the crosshair you would like to use - take a look at the
preview page before you select one.
3. Copy the PNG file to the clipboard either by right-clicking and choosing Copy,
or pressing CTRL+C.
4. Go to your Sauerbraten folder, and then to the "data" folder.
5. Paste the PNG image here, either by right-clicking and choosing Paste, or pressing
CTRL+V.
6. Delete the file "crosshair.png". You can recover this file from my package later,
if you would like so.
7. Rename the newly-added file "crosshair%.png" (where [%] is a digit from 1
to 10, depending on your choice of crosshair) to "crosshair.png".
8. You should now have a file called "crosshair.png", and if you preview it the
computer should display the
crosshair that you've chosen to use.
How can I recover the default crosshair?
Follow the instructions above, but make sure not to install any other crosshair
than the one named "default.png".
The file "default.png" contains the default Sauerbraten crosshair, and is not created
by me. It is only included
because you might need it.
How can I change the crosshair's in-game size?
When you are in the game, press T. Write "/crosshairsize N" (where
N is an integer between 0 and 50, 20 is recommended and 15 is default),
and press Enter. The crosshair's size should change. If the console says that the
command "crosshairsize" isn't found, try again by re-writing
the command.
Back